曝气浸没固定生物膜反应器处理化粪池出水

研究了以丝瓜络作为生物膜载体的曝气浸没固定生物膜反应器在处理化粪池出水时的可行性以及运行性能。结果表明,丝瓜络生物膜反应器可以在2周内成功启动;水力停留时间(HRT)对COD和氨氮的去除效果有显著影响,在水力停留时间为4 h的条件下,系统对COD和氨氮的去除率分别达到了78.5%和96.4%。另外,系统有较强抗有机污染物冲击负荷的能力,当COD和氨氮的进水浓度分别为59.3 mg/L和15.9 mg/L时,系统对有机污染物的去除效果较佳,去除率分别达到了80.0%和98.9%。     

人工湿地构筑根孔作用下土壤物质分布状况

嘉兴市石臼漾湿地应用人工构筑根孔技术,以玉米秸秆和油菜秸秆按比例混合埋植于土壤亚表层,作为湿地的基质/填料。在湿地运行一年半后,按照正交设计表,以埋植秸秆的种类(S)、填埋的土壤层次(L)、距离秸秆外环的远近(D)和秸秆周围土壤的表观颜色(C)作为实验因素,对秸秆周围养分物质浓度、土壤酶活性以及铁含量进行采样分析。实验结果显示:玉米秸秆和油菜秸秆腐烂较充分,分别形成较发达的粗根孔和细根孔;根孔周围土壤呈中度还原状态;粗根孔具有较强的优先流效应,其周围土壤具有较高的养分物质含量和较低的Fe2+/Fe3+比。粗根孔周围土壤具有较高的磷酸酶活性,而细根孔周围具有较高的β-葡糖苷酶活性和脲酶活性。综合比较,人工湿地构建初期,径级较大秸秆腐烂后形成的粗根孔发挥着更高的水分传导效率和更强的物质截留效应。     

潜流人工湿地水力学特性及工程设计

以净化低污染水体的潜流人工湿地水力学特性工程设计为重点，系统开展了室内外实验研究，并利用Peelet数分析了水平潜流人工湿地碎石床渗流返混程度。结果表明，潜流人工湿地集水花管孔口出流计算、基质填料内渗流计算、碎石床平均水力停留时间计算可分别借鉴薄壁孔口恒定淹没出流、线性或非线性渗流、活塞流理论；但受工程实际条件及运行淤堵等影响，工程实测结果均小于理论计算值。基于室内外实验成果，提出一套包括集配水系统水力计算、填料内渗流计算、平均水力停留时间计算在内的潜流人工湿地水力学特性计算方法和参数选择，可为人工湿地技术的工程设计提供借鉴。     

磨细粉煤灰自动装车除尘系统的研制

针对磨细粉煤灰由储料仓向罐式汽车内装料的作业特点,研制了自动化装车除尘系统,解决了装车过程中的粉尘污染问题,并实现了装车过程的自动化。     

Adaptive Management of Stream Channel Maintenance at Bridge Crossings in the Northern Tier Region,Pennsylvania1

Abstract: An adaptive management framework is applied to the problem of identifying mitigation measures for sediment deposition near bridge crossings in small streams in the Northern Tier region of northern Pennsylvania. The presence of the rigid bridge infrastructure introduces a challenge for applying adaptive management practices, because the integrity of the bridge structure itself has to be maintained regardless of the mitigation practices used in the stream channel near the bridge. In an effort to overcome the unacceptable risk that field‐scale adaptive management experiments present to rigid bridge infrastructure, an adaptive management approach for laboratory‐scale experimentation of mitigation methods at bridge crossings in the Northern Tier region is presented as a way to decrease the level of uncertainty about channel response to mitigation measures and increase the rate of learning about the effectiveness of these measures. Four cycles of adaptive management experiments are discussed to demonstrate that this approach results in fast and efficient learning about channel response to mitigation methods for the given conditions. The value of monitoring and of assessment of monitored data in the overall efficiency of the adaptive management approach is highlighted. Assessment of what was learned in the adaptive management experiment cycles presented here leads to new directions to continually improve management policies and practices in stream channels at bridge crossings in the Northern Tier region. The adaptive management process, rather than continuing with a normally risk‐averse management approach, results in opportunities for learning new information about a system’s response.     

Monte Carlo analysis of field water flow comparing uni- and bimodal effective hydraulic parameters for structured soil

Soil structure critically affects the hydrological behaviour of soils. In this paper, we examined the impact of areal heterogeneity of hydraulic properties of a structured soil on soil ensemble behaviour for various soil water flow processes with different top boundary conditions (redistribution and drainage plus evaporation and infiltration). Using a numerical solution of the Richards' equation in a stochastic framework, the ensemble characteristics and flow dynamics were studied for drying and wetting processes observed during a time interval of ten days when a series of relatively intense rainfall events occurred. The effects of using unimodal and bimodal interpretative models of hydraulic properties on the ensemble hydrological behaviour of the soil were illustrated by comparing predictions to mean water contents measured over time in several sites at field scale. Although the differences between unimodal and bimodal fitting are not significant in terms of goodness of fit, the differences in process predictions are considerable with the bimodal soil simulating water content measurements much better than unimodal soil. We also investigated the relative contribution of the soil variability of each parameter on the variance of the water contents obtained as the main output of the stochastic simulations. The variability of the structural parameter, weighting the two pore space fractions in the bimodal interpretative model, has the largest contribution to water content variance. The contribution of each parameter depends only partly on the coefficient of variation, much more on the sensitivity of the model to the parameters and on the flow process being observed. We observed that the contribution of the retention parameters to uncertainty increases during drainage processes; the opposite occurs with the hydraulic conductivity parameters.     

厌氧折流板式微生物燃料电池堆影响因素研究

微生物燃料电池(MFC)中输出电压/电流的提升,以及反应器体积的扩展放大是其工程化应用的关键。本文构建了一个总体积为6.4 L的新型厌氧折流板式微生物燃料电池堆(ABSMFC)。以葡萄糖作为底物,探讨了阳极材料、液面高程差和水力停留时间(HRT)等因素对ABSMFC性能的影响。结果表明,碳纤维毡作为阳极时,电池单体外电路平均分压(R_(ex)=1 000Ω)为210 mV,填充石墨颗粒后增加到319.8 mV。格室间存在液面高程差时,电池单体、串联和并联的功率密度分别为207.1、181.1和215.7 mW/m~2,当无液面高程差(即水力相连)时为205.8、69.5和151.5 mW/m~2。4个电池单体串联和并联连接时,HRT对ABSMFC的产电稳定性无影响,溶解性COD的去除率和库仑效率均随HRT的增加而升高,且并联效果优于串联。     

不同填料载体生物膜对微囊藻毒素的去除效果

利用自行设计的生物膜培养装置,通过对4种不同填料载体进行连续曝气循环培养生物膜,对湖水中的溶解态微囊藻毒素(MCs)的去除作用进行了研究。结果表明,填料载体上生物膜从形成到稳定大约需要3周;生物膜形成后对MCs的去除效率由高到低的顺序是:颗粒活性炭柱>多密孔球型滤料柱>塑料悬浮填料柱>陶瓷滤球柱。在实验水质条件下,当水力停留时间(HRT)=5 h,进水MCs浓度为21.5～47.25μg/L时,颗粒活性炭、多密孔球型滤料柱对MCs的去除率最高可达100%,塑料悬浮填料柱对MC-LR和MC-RR的去除率分别为70%和88%。当HRT=2.5 h时,塑料悬浮填料柱对MC-RR的去除率为MC-LR的2倍。生物膜对MCs的降解效果随温度(5～20℃)和溶解氧的升高而增加。塑料悬浮填料作为合适的生物膜挂膜填料载体对水源水的生物预处理具有良好的应用前景。     

交通荷载作用下饱和软粘土孔压-应变分析模型

针对交通荷载的作用特点设计了循环三轴试验,进而对交通荷载作用下饱和软粘土的动力特件进行厂研究.结果表明:循环荷载作用下,饱和软粘土存在临界循环应力比,采用孔压曲线所得到的临界循环应力比要小于采用应变曲线所得到的临界循环应力比.当土样不存在初始剪应力时,随着循环次数的增加,土样的应力-应变关系曲线近似原点对称,但随着初始剪应力的增大,应力-应变关系曲线逐渐表现为一系列平行曲线,峰值孔压与循环孔压幅值均逐渐减少;同时,轴应变的发展加快,但循环应变幅值逐渐减小.当循环应力比小于临界循环应力比时,对于同一初始剪应力,不同循环应力比下的孔压比-动应变曲线近似集中在同一条曲线上.通过对试验数据进行回归分析,得到了交通荷载作用下饱和软粘土残余孔压-累积塑性应变关系模型.     

多隔室厌氧折流板反应器(ABR) 的水力特性试验研究

对ABR反应器的水力流态进行了示踪剂试验,分析了特征截面面积对ABR水力特性的影响,采用停留时间分布(RTD)法研究了不同进水COD浓度和HRT条件下ABR反应器的水力特性,结果表明不同进水COD浓度时ABR反应器的RTD曲线相似,表明进水COD浓度不是影响ABR水力特性的主要因素;不同HRT条件下RTD曲线差异很大,表明HRT对ABR的水力特性影响较大,随着水力停留时间的延长,N值增大,1/Pe减小,ABR的流态趋于推流流态,随着HRT的缩短,N值减小,1/Pe数增大,ABR反应器趋于完全混合流态.